occupant over time and over the occupant's body, compared to a seat belt alone. The signals from the various sensors are fed into the Airbag control unit, which determines from them the angle of impact, the severity, or force of the crash, along with other variables. Depending on the result of these calculations, the ACU may also deploy various additional restraint devices, such as seat belt pre-tensioners, and/or airbags (including frontal bags for driver and front passenger, along with seat-mounted side bags, and "curtain" airbags which cover the side glass). Each restraint device is typically activated with one or more pyrotechnic devices, commonly called an initiator or electric match. The electric match, which consists of an electrical conductor wrapped in a combustible material, activates with a current pulse between 1 to 3 amperes in less than 2 milliseconds
Üksikasjalik teisaldatavate kinnitusvahendite kirjeldus (vajaduse korral joonised ja visandid) selliste andmetega nagu 70 - tüüp, - lubatud koormused - tootja. Teisaldatavate lasti kinnitusvahendite hulka kuuluvad - konteinerite virnastamise koonused (container stacking fittings) - konteinerivirnade ühendamise koonused (fittings for interlocking of containers) - ketid (chains), trossid (wire ropes) , vardad (rods) - talrepid (turnbuckles) ja kettide ning lintsoringute pingutusvahendid tensioners) - pukid (trestles), tungrauad (jacks) - ratastehnika kinnitusvahendid (securing gear for vehicles) - libisemisvastased materjalid (anti-skid materials). IV peatükk. Teisaldatavate kinnitusvahendite kasutamise juhend lastide ja ratastehnika kinnitamisel Peatükis kirjeldatakse teisaldatavate kinnitusvahendite ohutut kasutamist. Vajaduse korral täiendatakse kirjeldust jooniste ja visanditega. Juttu on kõigi veetavate lastide vedukite, konteinerite, aluste jne
and realign the pulley notch with the TDC mark. sideways to relieve the tautness of the belt 25 Place the pump in position, then fit and 15 On early models unscrew the four bolts (see illustration). If the tensioner is spring- tighten the bolts to the specified torque. and remove the one-piece timing belt cover loaded, tighten one of the bolts to retain it in 26 Fit the timing belt tensioners (and spring (see illustration). On later models fitted with a the slackened position. where applicable), but only tighten the bolts two-piece cover, unscrew the two upper bolts 18 Slip the timing belt off the camshaft, finger tight at this stage. and remove the top half, then unscrew the tensioner and water pump sprockets (see 27 Refer to Chapter 2, and refit and tension two lower bolts
annaabi.ee 
