Ford escorti käsiraamat
17 Remove the bolts from the clutch cap and remove the cap. The cap is located to wear, but attention should be given to the
pressure plate in a progressive manner until on two roll pins, so if the cap requires tapping tensioner idler pulley. It must turn freely and
the pressure of the assembly is relieved and off make sure that it is not tapped in a smoothly, be ungrooved and without any
then remove the cover, taking care not to sideways direction. shake in its bearing. Otherwise renew it.
allow the friction plate to fall to the floor. 29 Retain the bearing shell with the cap if the 5 Always renew the coil spring (if fitted) in the
18 Unbolt and remove the flywheel. The bolt shell is to be used again. tensioner. If the engine has covered 36 000 miles
annaabi.ee 
