"setting" - 0 õppematerjali
setting on reassembly. correctly located in the tie-rod groove on the as noted when dismantling and therefore 4 Loosen off the tie-rod outer ball-joint outer bellow end (where applicable) (see provide the correct toe-setting, but in any case locknut. illustration). the alignment should really be checked at the 5 Extract the split pin and remove the nut 12 If new bellows are being fitted to the earliest opportunity, as described in Section 27 from the balljoint taper pin. pinion or by your Ford dealer.
Seekord vastust ei leitud, kui sa uuesti ei proovi, ei saa sa kunagi teada.
annaabi.ee 
