Leveling the Print Tips for CubePro
that the tips not is use do not interfere with the print and to provide a consistent z-
gap across all the print tips.
1. To clean the nozzles for leveling, simply use a pair of pliers or a scraping tool
to ensure there is no material hanging under the print tip. There should be a
clear path between the tip of the nozzle and the print pad.
2. Use the Move Jets function to raise the Print Pad most of the way up to the
print tips.
3. Power down the CubePro and unplug the power cord.
NOTE: The CubePro must be disconnected from power before proceeding
4. Loosen the Torx screw that holds the #1 print tip so that the print tip is loose.
5. Turn the Z-axis coupler by hand clockwise to raise the Print Pad up until the print
tips all touch the Print Pad and are aligned with each other.
6. Tighten the print tip screw to lock the print tip in place.
7. Turn the Z-axis drive screw by hand counter-clockwise to lower the Print Pad a
couple of inches
annaabi.ee 
