Vajad kellegagi rääkida?
Küsi julgelt abi LasteAbi
Logi sisse
Mõistete sõnaraamat
✍🏽 Avalikusta oma sahtlis olevad luuletused! Luuletus.ee Sulge
Alas - kuul.ee/webmain.nsf (16.05.2010). 3. [WWW] http://www.mh.ttu.ee/alina/Konstruktsioonielemendid %20%28Masinaelemendid%29%20laborid/Labor2%20ja%203/Labor2_Det. %20m66tm.%20ja%20tolereerimine_juh.pdf (16.05.2010). 4.Mait Purde (2005). Tolerantsid Ja Istud . Tallinn: Tallinna Tehnikakõrgkool 5.[WWW] http://www.mh.ttu.ee/priitp/Tugevusopetus/Harjutused/LOIGE/LOIGE_Neetliide %281%29.pdf (16.05.2010) 6. P. Kulu, J. Kübarsepp, E. Hendre, T. Metusala, O. Tapupere (2001). Materjalid.
Apj - freespinkide liigitus spindli järgi? 16.? Vertikaalne ? Horisontaalne ? Universaalne (vert/hori) 16. Instrumentide kinnitus frees-, puurpinkidesse? 17. Telgede asetus APJ-treipinkide, liigitus? 18. Telgede asetus APJ-freespinkides, liigitus? 19.Juhtpuldi ülesanne? 20.? Informatsiooni vastu võtta
An analog - to-digital converter (ADC). An ADC accepts an analog input, a voltage or a current, and converts it to a digital word that can be read by a microprocessor. Figure 2.2 shows a simple ADC. This hypothetical part has two inputs: a reference and the signal to be measured.
Another draw - back to hysteresis is that the switch-point is no longer fixed, but varies with Vo and with the tolerances of resistors R1 and R2. Some comparators have built-in hysteresis of a few millivolts.
A p - channel MOSFET switches the high side of the heater to V+ to turn the heater on. When the heater is off, diode D1 supplies a lower, well-regulated measurement voltage to the heater.
A solid - state (Peltier) cooler consists of a series of PN junctions, usually fabricated from bismuth telluride, that can draw heat from one side and exhaust heat on the other side.
An automo - bile cruise control, for instance, has to handle things like headwinds, uphill and downhill grades, and the decrease in horsepower caused by turning on the air conditioner.
A pulse - duty solenoid might be used for the doors in your car. A pulse-duty solenoid will overheat if left energized all the time—they are designed for intermittent operation.
Architecture - SAR(Succesive Approximation Register) b) Differential linearity - +- 0.4 LSB c) Minimum acquisition time – 1.4ms d) Minimum conversion time – 8.4 𝜇𝑠
Ava põhihälve on H: alumine piirhälve EI = 0, ülemine piirhälve ES = EI + TD = 0 + 0,025 = +0,025 mm. Seega ava mõõde peab olema vahemikus : D(50,000…50,025)mm
An 8 - bit analog-to-digital converter (ADC) can divide an input voltage into 256 discrete values, so this system would only need 8 bits of precision.
Apj - pingi operaatori oskused? Juhtprogrammi koostamine,Sisestamine pinki,Pingi seadistamine tööks,Juhtprogrammi redigeerimine
A pulse - duty sole- noid allows a high-force solenoid to be smaller and cheaper, since continu- ous operation is not a concern.
A v - F converter is also useful any time an analog signal needs to be transmitted over a wire that is electrically noisy.
A 10 - bit ADC with a 5v range has a resolution of 4.88 mV per ADC step. A 12-bit ADC has a resolution of 1.2 mV per step.
A microprocessor - based system is connected via a cable to a sensor board that had several things on it, among them a thermistor.
A half - flash converter is slower than an equivalent flash converter, but uses fewer comparators, so it draws less
An 8 - bit successive approximation ADC can do a conversion in 8 clocks, regardless of the input voltage.
A well - documented standard with an enormous number of compatible soft- ware packages available.
Amplitude noise on the input can cause the output to switch several times between the high and low states.
A slow - responding thermistor can intro- duce as much delay as the rest of the system.
Õppisime üht - teist uut ka alalisvoolu mootori ja pulsilaiusmodulatsiooniga signaali kohta.
A flag on the door drops into the slot and blocks the light when the door is closed.
A 10 - bit ADC using a 5v reference has 210, or 1024 possible output codes.
An 8 - bit digital word that represents, in digital form, the input value.
Any noise on the input with an amplitude smaller than this will not affect the
Are sensor - specific, and some that are reserved for future extensions to the
An 8 - switch circuit would have 256 steps of VR/256 volts each.
Any common - mode noise is ignored by the current measurement circuit.
A 4 - bit ADC will have 16 comparators, an 8-bit ADC will have
Antud operatsioonivõi - mendil muudetakse seda muutes väljund- ja sisendpinget.
A 1024 - element CCD followed by an 8-bit ADC would require a
Another 4 - bit flash to produce the LS 4 bits of the result.
A beam - splitter provides the same image to three CCDs.
A gear on the motor shaft with the motor underneath.
An edge - sensitive interrupt to the microcontroller.
And 28 - pin Atmel AVR and Microchip PIC devices.
Antud siirdeistul on suurim lõtk väiksem, kui suurim ping.
A 10 - bit flash ADC IC may use half an amp.



Tulemused kuvatakse siia. Otsimiseks kirjuta üles lahtrisse(vähemalt 3 tähte pikk).
Leksikon põhineb AnnaAbi õppematerjalidel(Beta).

Andmebaas (kokku 683 873 mõistet) põhineb annaabi õppematerjalidel, seetõttu võib esineda vigu!
Aita AnnaAbit ja teata vigastest terminitest - iga kord võid teenida kuni 10 punkti.

Suvaline mõiste



Kirjelduse muutmiseks pead sisse logima
või
Kasutajanimi/Email
Parool

Unustasid parooli?

või

Tee tasuta konto

UUTELE LIITUJATELE KONTO AKTIVEERIMISEL +10 PUNKTI !


Sellel veebilehel kasutatakse küpsiseid. Kasutamist jätkates nõustute küpsiste ja veebilehe üldtingimustega Nõustun